Cement Mortar Specimen Moulds

Cement mortar specimen moulds are used to prepare prism or cube specimens for strength testing. Their dimensions and number of compartments depend on the applicable method and must not be confused with 150 mm concrete cube moulds.

Concrete versus mortar moulds

Concrete commonly uses larger cubes or cylinders, while cement mortar procedures often require smaller multi-compartment prism moulds. State the standard, internal size and number of compartments.

• Specimen geometry
• Internal dimensions
• Number of compartments
• Material and dismantling requirement

Verification before ordering

Check the laboratory procedure, equipment arrangement and referenced standard together. AYKOMSAN can review a dimension list or technical drawing before quotation.

• Standard number
• Drawing or size list
• Daily casting volume
• Cleaning method

Users and maintenance

Typical users include cement plants, material laboratories, universities and quality control units. Keep surfaces clean and avoid forcing the mould during specimen removal.

Custom requirements

For non-catalogue dimensions, provide geometry, tolerance, material preference and quantity. Manufacturability and lead time are confirmed only after technical review.

Reliable results in practice

Specimen mould selection is only one part of the concrete or mortar testing workflow. Comparable results also require representative sampling, correct placing and compaction, clear specimen identification and curing under the conditions required by the applicable procedure. Inspect the mould before use. Hardened residue, cracks, severe wear or visible distortion should trigger cleaning, dimensional verification or replacement. On products designed for compressed-air release, keep the inlet clear and apply pressure gradually; do not force the specimen with impact tools. Before purchase, confirm the product code, internal dimensions, body weight and material in writing. This prevents confusion between products that have similar names but different geometries. Where the laboratory quality system requires it, verify internal dimensions at planned intervals with suitable measuring equipment and retain the inspection records. The current project specification and the latest edition of the referenced test standard always take precedence over general product information.

Quotation and technical support

Send the referenced method and required dimensions through the quotation form.